WH08X32697 WH08X37938 Washer Door Lid Lock Switch - For GE Washing Machine

WH08X32697 / WH08X37938 Washer Door Lid Lock Switch

Key Features

• Cycle Security: Prevents the lid from being opened during the agitation and high-speed spin stages to ensure operator safety.
• System Feedback: Relays the lid position to the electronic control board to permit the machine to fill, wash, and spin.
• Reinforced Design: Features an updated internal solenoid and strike receiver to resist mechanical wear and electrical arcing.
• High-Impact Housing: Enclosed in a moisture-resistant plastic casing to protect internal electrical components from steam and splashing.

Replaces / Cross-Reference Part Numbers

• AP7015047
• PS16619254
• WH08X37938
• WH08X31577
• WH01X27954
• WH01X26114
• WH01X24114
• EAP16619254
• PD00067861
• WH08X32657

Compatibility & Fitment

This lid lock switch assembly is used in various top-load washing machines from GE and affiliated brands. Compatible models include:

• GE GTW Series: GTW465ASN1WW, GTW460ASJ3WW, GTW460ASJ2WW, GTW330ASK3WW, GTW220ACK1WW, GTW460ASJ0WW, GTW460ASJ1WW, GTW465ASN0WW.
• GE GTW220 Series: GTW220ACK2WW, GTW220ACK3WW, GTW220ACK4WW.
• Additional Brands: Fits select top-load models from Hotpoint and Kenmore (prefix 110) that utilize the GE-style latching system.

When to Replace

• Lid Fails to Lock: The machine hums or clicks several times but the "Locked" indicator light does not illuminate.
• Cycle Stalling: The washer fills with water but refuses to agitate or spin, often accompanied by a flashing lid lock light.
• Physical Damage: The plastic receiver port where the lid strike inserts is cracked, preventing a secure mechanical connection.
• Electrical Faults: The washer displays fault codes related to a "Lid Switch Circuit" or "Lock Monitor" failure.
• Fails to Unlock: The lid remains locked even after the cycle is finished and the power is disconnected.

Installation Tips

• Safety First: Completely disconnect the power cord and turn off the hot and cold water supply valves before servicing.
• Accessing the Component: Use a flat-head screwdriver or putty knife to release the hidden clips under the front corners of the top panel to tilt the console back.
• Harness Routing: Pay close attention to how the wiring harness is routed through the plastic clips to prevent the wires from being pinched when the top panel is lowered.
• Strike Alignment: Inspect the lid strike (the part attached to the lid) for damage; if it is bent, the new lock switch may not engage correctly.
• Resetting the Board: After installation, you may need to enter the service mode or unplug the machine for one minute to clear any stored error codes.